The Woodshop Shed

Crown Royal tipper

Furnished content.
(from Lumberjocks.com)


i had a request to make a tipper for a crown royal bottle. i have made several for wine bottles so i accepted the challenge.
The board is 5 1/2 ” wide by 12 1/2” long.
I drilled an 1 1/2” hole 6 1/2 inches from the bottom.
I cut the ends at a 30 degree angle.
finished with 2 coats of tung oil varnish and a couple coats of laquer after the tung oil dried.
fun project and conversation piece when people try to figure what holds the tipper up without tipping over.

0 comment(s)