April 2024 |
Sun |
Mon |
Tue |
Wed |
Thu |
Fri |
Sat |
|
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
21 |
22 |
23 |
24 |
25 |
26 |
27 |
28 |
29 |
30 |
|
|
|
|
|
|
VCU Hand and Power Tool Safety
Furnished content. (from WoodNet.net)
VCU Hand and Power Tool Safety Program guide
Academia edu may require opening a free account to down load.
I get occasional emails from them for woodworking related articles and frequent emails about articles related to my work.
The links to woodworking articles did not start until the first time that I downloaded one.
Read more here
posted at: 12:00am on 15-Apr-2024 path: /Woodworking | permalink | edit (requires password)
Big table top!
Furnished content. (from WoodNet.net)
I am finishing up what I consider an odd sized table. It is 5' x 5' out of 1 3/8" thick walnut. Heavy top, so heavy that since I work by myself, I had to design a apparatus to move and flip the top over.
The schrinkulator calculates an 1" of movement if I put in the high value of 12% and the low value of 6". I would think that would be the extremes or at least I hope so!
I was going to use figure eights to fasten the top to the apron but I am concern that figure eights would not handle that much possible movement. Thoughts?
The base is 35" x 35" with 5" x 5" legs and 2" x 5" aprons. I was only going to put the figure eights parallel to the grain. Would it be a mistake not the attach the sides of the table to the base in some way? Once again, there is a potential of a considerable amount of movement.
Thoughts?
Thanks,
Toney
Read more here
posted at: 12:00am on 15-Apr-2024 path: /Woodworking | permalink | edit (requires password)
April 2024 |
Sun |
Mon |
Tue |
Wed |
Thu |
Fri |
Sat |
|
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
21 |
22 |
23 |
24 |
25 |
26 |
27 |
28 |
29 |
30 |
|
|
|
|
Promoted by Feed Shark
|
|