| June 2026 |
|---|
| Sun |
Mon |
Tue |
Wed |
Thu |
Fri |
Sat |
| |
1 |
2 |
3 |
4 |
5 |
6 |
| 7 |
8 |
9 |
10 |
11 |
12 |
13 |
| 14 |
15 |
16 |
17 |
18 |
19 |
20 |
| 21 |
22 |
23 |
24 |
25 |
26 |
27 |
| 28 |
29 |
30 |
|
|
|
|
|
|
24" Incra Miter Runner Question
Furnished content.
(from WoodNet.net)
Hello All,
I have two 24" Incra Miter Sliders. I used them for a TS Sled and I wanted to make a new sled so I took the sliders off and I was trying to adjust the hex screws (which tighten so the runner fitssnugly in the miter slot) and I noticed that several of the 3/32" adjustment holes were stripped. I did contact Incra and they replied right away with a link to order more from their site. They sell them in packs of 3 for $4.95 with $6.00 shipping. That is not too bad but I was wondering if anyone knew where to source the screws directly? I asked ChatGPT and ChatGPT gave me the following spec:
#6-32 x 3/8 flat head socket cap screw
That seems right but then it went on about a head angle of 82 or 90 degrees? The head angle may not matter.
Anyone know the correct spec and where do buy the screws? Attaching a picture from an internet search.
Thanks, Bill
 Screw.jpg (Size: 69.61 KB / Downloads: 42)
Read more here
posted at: 12:00am on 07-Jun-2026
path: /Woodworking | permalink
comment...
| June 2026 |
|---|
| Sun |
Mon |
Tue |
Wed |
Thu |
Fri |
Sat |
| |
1 |
2 |
3 |
4 |
5 |
6 |
| 7 |
8 |
9 |
10 |
11 |
12 |
13 |
| 14 |
15 |
16 |
17 |
18 |
19 |
20 |
| 21 |
22 |
23 |
24 |
25 |
26 |
27 |
| 28 |
29 |
30 |
|
|
|
|
|
|