I did this project for the WOOD TURNING CHALLENGE for April. The presentation picture was it in its simplest form, Then you can add another turning in the canter and it becomes two tiered.Or just a dish in the center if one was serving dips etc.Or you might want to use it for a romantic occasion with treats.A nice decoration can also be put in the center.I turned this from a 14 inch thick square pf birch. The design was to have the outer rim fold around and then lathe the bottom side till one lathed through the flat sides, easier said than done. for some reason. laying out the projectstart of the bottom side, top was done last.continue lathing till you can see right though.The top rings where done in iridescent gold. I was thankful I didn't cut the sides when I was making the hand hold big enough right off. close though. I would have just given upThanks for looking, comments appreciated