May 2024 |
Sun |
Mon |
Tue |
Wed |
Thu |
Fri |
Sat |
|
|
|
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
21 |
22 |
23 |
24 |
25 |
26 |
27 |
28 |
29 |
30 |
31 |
|
|
|
Hand Crank
Furnished content. (from Lumberjocks.com)
This is a hand crank for my next project. It is made from walnut and a strip of maple in the handle. It has a 1” hex socket cut in it for the nut it will drive. The handle has a 7 1/2” throw from center of the handle to center of the socket.I added a few shots of making the hex socket. I faced off all the radius on the nut in the lathe so it had a sharp edge all around. Then I bored a 1” hole 1 1/2' deep and a 3/4” hole for the rest 1/2”. I used a 3/4-10 bolt to align the nut to the hole and broached in the hex in the vise. A little work with a chisel to give it some clearance and it works real good. I used a piece of pipe a little longer than the inside of the handle and 3/8” cap screw to hold it together. There is a 44 mag cartridge ( compliments of LJ Hillbillyshooter) in a piece of black nylon to cover the 3/4” holeIt is finished with Danish oil and buffed and waxed.Cheers, Jim
Read more here
posted at: 12:00am on 21-Jul-2022 path: /Woodworking | permalink
comment...
May 2024 |
Sun |
Mon |
Tue |
Wed |
Thu |
Fri |
Sat |
|
|
|
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
21 |
22 |
23 |
24 |
25 |
26 |
27 |
28 |
29 |
30 |
31 |
|
|
|