Furnished content.
(from Lumberjocks.com)
Built a little box to hold a bottle of (red) wine. I got tired of my older design with the sliding lid, and wanted to try something new. There are two oak uprights staked into the oak bottom of the box with wedged tenons. Used my hollow auger to make the round tenons, and then drilled holes to fit. Three sides of pine from a board that turned into a potato chip when I tried dovetailing it for a bookcase are glued into grooves cut in the uprights. Waste not want not. And then the lid, which makes up the front and top (waterfall grain, donchaknow), and which connects to the bottom with a mortise and tenon, and latches to the back to hold it closed.The bottom has a hand-carved inset to keep the bottle of wine in place, and the box is a tight enough fit that I should be able to transport a bottle to a neighbor's without mishap, if things ever get to the point that we can socialize with the neighbors again.The whole thing was planed smooth before being assembled, hand-sanded with a 400 grit sanding block (no matter how sharp the plane blade, I can't manage to smooth that spalted elm with a plane), then got four or five coats of shellac and got glued together. The little diagonal braces are pieces of thick bubinga veneer I had left over after reinforcing my brace till – they went on kinda late in the game when I realized my miter joint wasn't going to be very strong, especially as the spalted elm feels about like balsa wood (but it drank a few ounces of shellac, so that firmed it up a bit). There's a cheap little latch I bought a dozen of a while back because I needed one, but didn't like the looks of the price for one, so bought a dozen to get the volume discount.I think that's about it. It's not a great design, but it's different, and it distracted me from bookcases for a week. Don't know if I'll make another like it, or whether it'll be a one-off-kind.