Furnished content.
(from Lumberjocks.com)
I have been woodworking except for my college years, since I was 18 years old and had never made a box joint box.I have seen many shop made and expensive box joint jigs but did not want to spend time to make one or spend money to buy one. So one day I said to myself ”self, there must a simpler way”. So playing around with my router table and my router sled I made spacers that fit between the router sled and the router table fence and made this box. For this box I only needed three spacers.The body is 1/4” maple, the top 1/8” Midwest baltic birch plywood that I veneered with mahagony veneer on both sides, finished with several coats Varathane satin water based polyurethane, 4 1/16” diameter neobidium magnets, and inset hinges.This is another “stuff from my shop” projects where I only used stuff in my garage.Total material cost was $0.00!