Drawer Lock Bit - Drawer Stock Sizing Question
Furnished content.
(from WoodNet.net)


I just bought the Freud Drawer Lock bit. It isFreud 99-240: 2" (Dia.) Drawer Lock Bit with 1/2" Shank - Perma-SHIELD Coating Red -


OK, can't find this anywhere....how do I size the drawer if I am using this bit? For example, if my finished drawer length needs to be 21",

do I use a 21" side or do I have to adjust the measurement because of the bit I am using? If my finished size is to be 21" deep (the sides) and 15" wide,

I would usually (assuming 1/2 thick stock) make my sides 21" and my front and back 14". Then, with a simple butt joint, my finished drawer would be 21" X 15".

If I use this bit, would that be the same? Or would my prepared stock dimensions have to change to accommodate the bit in order to get the desired final dimensions?



Thanks in advance.

Read more here

edit: Woodworking/auto___drawer_lock_bit___drawer_stock_sizing_question.wikieditish...