Furnished content.
(from WoodNet.net)
Hello All,
I have two 24" Incra Miter Sliders. I used them for a TS Sled and I wanted to make a new sled so I took the sliders off and I was trying to adjust the hex screws (which tighten so the runner fitssnugly in the miter slot) and I noticed that several of the 3/32" adjustment holes were stripped. I did contact Incra and they replied right away with a link to order more from their site. They sell them in packs of 3 for $4.95 with $6.00 shipping. That is not too bad but I was wondering if anyone knew where to source the screws directly? I asked ChatGPT and ChatGPT gave me the following spec:
#6-32 x 3/8 flat head socket cap screw
That seems right but then it went on about a head angle of 82 or 90 degrees? The head angle may not matter.
Anyone know the correct spec and where do buy the screws? Attaching a picture from an internet search.
Thanks, Bill
Screw.jpg (Size: 69.61 KB / Downloads: 42)Read more here