Furnished content.
(from Lumberjocks.com)
This is an extending dining table I completed for a client who gave me creative license on design. The top is QS Sapele (1/16 veneer) with a maple border with black lacquer.It was a bit tricky to determine how to do the black border. I had planned to do a pre-cat lacquer finish for its durability. I had read that you could paint using a flat latex and then lacquer over that. But the tech folks at Sherwin Williams highly discouraged this. So I went with the black lacquer.Then – do you finish the border and then assemble? If so, you risk gaping and sanding issues. Or do you assemble and sand, and then tape off? This was scary to do, but I opted to tape off. The Frog Tape worked fabulously.Finally, note the stretcher is a double arch. It's a nice oriental aesthetic but also a pretty stable structural element. Some process photos below…Any and all comments or critique are welcome!First image is a creative way to do my large mortise for the trestle base.
Next is the monster trestle mortise and tenon.
Substructure to support the Osborne extension slides (half lap with shoulders:
Stretcher bent lamination:
Veneer vacuum and veneer waterfall (on substrate):
Border joint and black lacquer after taping: