Power Tools (Drill, Driver, Jigsaw, Oscillating, Circ) + Accessories & Charging Rack
Furnished content. (from Lumberjocks.com)
Here is the Hand Power Tools & Accessories rack that I built to hang on my french cleat wall.It holds my Drill, Driver, Jigsaw, Oscillating Tool, 4-1/2” Circular Saw and most of the various accessories that go with these tools (at least the ones that get used often). The chargers are mounted properly to allow for single handed on- and off-ingNothing too special about the build. I just googled for some examples and found one that fit my needs. If it were to build it over again, I would add more cubbies (once I realized that I could fit more than just the drill & driver on it, it filled up quickly) and I would make some of the cubbies larger than the others. I would also probably add a third shelf.
Read more here
posted at: 12:00am on 31-Jan-2021 path: /Woodworking | permalink | edit (requires password)
Pliers, Snips, & Vise-Grip Storage Solution for French Cleat
Furnished content. (from Lumberjocks.com)
I'm pretty happy with this one, guys.I had some old unused shelving from my shop renovation. I cut it half, turned it on its side and violin! A made-to-order pliers, snips, and vise-grips storage solution.The build: I cut a backer board which spans two of the french cleats. I then simply aligned and affixed the modified shelves to the backer by screwing wooden “washer” pieces that span at least 3 of the 'rungs'. I wasn't sure if they'd be enough to hold the weight (and the final decision there is yet to be seen when/if I fill it up) but it's been doing perfectly so far!
Read more here
posted at: 12:00am on 31-Jan-2021 path: /Woodworking | permalink | edit (requires password)
Bench Hammer
Furnished content. (from Lumberjocks.com)
Forged. Handle is Gabon Ebony. Approximately 14oz
Read more here
posted at: 12:00am on 31-Jan-2021 path: /Woodworking | permalink | edit (requires password)
Promoted by Feed Shark
|
|