Drill Press Table
Furnished content. (from Lumberjocks.com)
Just finished a small drill press table. I've hated trying to clamp things to the edge of the cast iron. A nice feature I added is a swing out box for small drills and taps
Read more here
posted at: 12:00am on 15-Jan-2020 path: /Woodworking | permalink | edit (requires password)
Redwood, soft maple and elm box # 6
Furnished content. (from Lumberjocks.com)
My fourth post in a series of nine box art projects using reclaimed redwood. Each posting features a unique box in the main pictures and a narrative focused on a different step in the process. Sometimes including photos from parts of other projects in the series; click on “my next or previous project” to read the whole series.Redwood, soft maple and elm box # 6- 6×9 x 4.25 inches
- Box joints with a skip pattern
- Four-way book matched burl top
- Soft maple trim, splayed feet and hinges
- Sliding, removable tray
- Brass knob and clocked, sculpted hinge screws
- Ribbon lock in dark purple
Reclaimed Redwood, a gift from my sister, plus soft maple trim and Redwood burl purchased from Rare Woods & Veneers – Carlton McLendon, Inc.Pictures and comments during making of the splayed feet: Objective: a bit of Mid Century modern look and enough room under the box to easily pick it up.Cut 1/2 inch square pieces: Using a quarter round bit and stop blocks at the router table, I formed dowels in the center section of the square stock by rotating 90 degrees on each pass (safety first): Cross cut at 25 degrees and 3/4” long: Built a fixture for the drill press to hold pieces at compound angle 25 degrees and 45 degrees: Drilled 1/2 inch holes into corner of would be mounting blocks, 3/16 inch thick, using a protective piece of scrap above and below to accomplish clean holes: Cut the mounting blocks to size, rounded over the edges that would show and dry fitted to each box: Tuned the fit on sanding board, glued them into the mounting blocks with CA glue: Signed and tied up with a bow: Thanks for reading my post. The main pictures in full resolution are also posted at https://www.flickr.com/photos/mrlaughingbrook/albums/72157712543557228. Comments or questions are welcome. I'll post the next one in a day or so…
Read more here
posted at: 12:00am on 15-Jan-2020 path: /Woodworking | permalink | edit (requires password)
Small Parts Sled
Furnished content. (from Lumberjocks.com)
Knocked out a small parts sled for a couple upcoming projects. I was thinking of painting the safety fin on the back in candy apple red with a white racing stripe :-)
Read more here
posted at: 12:00am on 15-Jan-2020 path: /Woodworking | permalink | edit (requires password)
Promoted by Feed Shark
|
|